Page 20
CCRadio2E
Radio Operation
AUDIO & RECORDING JACKS
The jacks on the back left side of the radio are for audio input (AUX IN),
audio output (LINE OUT) and a timer activation switch
.
AUX IN JACK
The green jack, labeled AUX IN, is used to connect an external audio
source such as a CD Player or recorder, so you can listen through your
CCRadio2E’s speaker. To do this, you will need an appropriate patch cord
(1/8” (3.5mm) stereo).
Warning: If a “LINE OUT” is not available on your external audio
source, you can use the headphone jack. However, the volume must
be kept low or damage to the CCRadio2E may result.
1) Plug your patch cord into the LINE OUT or Headphone Jack of your
external audio source.
2) Plug the other end into the AUX IN jack on the CCRadio2E.
3) With the power on, press and hold the
BAND/AUX
button until you hear
a short beep and AUX appears on the display.
4) Turn on your external audio source to hear the audio played through the
CCRadio2E.
5) To turn the AUX off, press the
BAND/AUX
button again and the AUX
will disappear from the display.
NOTE:
Volume can be controlled from the CCRadio2E.
AUX IN JACK
TIMER ACTIVATION
SWITCH
LINE OUT JACK
Left Side
Back of Radio
