TWIN COIL FERRITE AM ANTENNA
Page 9
Initial Setup
Connection to Radio and
Antenna
These instructions cover the
basic setup.
Attach one end of the 5' PS2
cable to the jack, labeled
To Antenna, on the back of the
Tuner Control unit. The arrow on
the plug should face up. Please,
DO NOT force the plug into the
Tuner Control. It will plug in nicely
when the pins are aligned.
Connecting Antenna Element
The other end of the PS2 cable
will plug into the jack on the
Antenna Element labeled
To
Control Box
. The arrow on this
plug should also face up.
Antenna Element
The first time you use the Twin Coil Ferrite AM Antenna by C. Crane it
takes time, planning, and a little bit of patience. You will need to re-check
and re-tune the unit to find the best position.
After you have found the best spot for the Tuner Control, Ferrite Stick,
and Antenna Element, you can take the time to secure and make
permanent the installation to your liking. The Ferrite Stick can be fixed to
the radio using the included hook and loop fastener.
If you have a problem finding a location for the Antenna Element that
produces good results, be sure to try different areas within 50' of your
radio. If you find a good position, you have the option of locating the
Antenna Element there. If you need to mount the Antenna Element away
from the radio for best reception, you may order additional cable in
longer lengths.
Please refer to
Tuner Control
To Radio To Antenna 9VDC
PS2 cable
To Antenna
1/8” Mono
x RCA
To Radio
