17
Removing the Pump
CAUTION
To prevent damage to the pump and tank connector ensure the tank is upside down when removing the pump
cover
. Remove the vacuum release valve first to prevent damage.
1.
Remove the vacuum release valve.
2.
Place the sprayer upside down.
3.
Remove the six screws securing the pump cover and remove the cover (SR50/80 only)
4.
Unclip the suction and delivery hose connections by pulling the blue tabs into the unlocked position.
5.
Unscrew the four mounting screws hold the pump in place (SR35 only)
6.
Lift out the pump.
Installing the Pump
CAUTION
To prevent leaks,
never
use thread tape on the suction or delivery hose connections as this may prevent proper
sealing of the cones. Do the nuts up finger tight then advance the nuts one quarter turn.
1.
Place the pump in the pump cavity as shown above.
2.
Connect the suction and delivery hoses.
3.
Screw four mounting screws into inserts (SR35 only)
4.
Replace the pump cover. (SR50/80 only)
CAUTION
Always operate the SR50/80 with the pump cover in place. The pump cover holds the pump in position
SR50/80 Style
SR35 Style
Summary of Contents for SPRAYRIDER Generation 2
Page 19: ...19 SR50 80 PARTS DIAGRAM...
Page 22: ...22 SR35 PARTS DIAGRAM...
