One Partition
If only one partition is configured in the device, then the LED indicates the partition status, the presence of an
alarm during protection and faulty zones:
∙
LED is on continuously if the partition is armed;
∙
LED is not on if the partition is disarmed;
∙
the LED “flashes” (blink), if there are faults in the zones;
∙
the LED “flashes”, if after the partition was armed, there was an alarm and the partition was not disarmed.
“Flashing” means that the LED turns on for 1 second, then turns off for 1 second, then turns on again
for 1 second, etc.
Several Partitions
If several partitions are configured in the device, then only the following is indicated: the entire device arming,
presence of an alarm, when the entire device was under protection, and also the zone faults.
∙
LED is on continuously if all device partitions are armed;
∙
LED is off if at least one of the partitions is disarmed;
∙
LED “flashes” if there are faults in the zones;
∙
LED “flashes”, if after the device was armed, there was an alarm and the alarmed partition was not disarmed.
2.2
K14-LED Keypad
Figure 2: K14-LED keypad
12
