Disarming Indication
If the disarming is allowed, then
≪
DISARMING...
≫
is displayed on the first line of the keypad screen for 3 seconds,
after which the keypad screen switches to the standby mode corresponding to the device security status.
If according to the site settings in the Security Center software the user shall be informed about the need to pay
for security services during arming and disarming, the second line of the keypad screen displays the phrase
≪
PAY
FOR SECURITY!
≫
.
Example of a keypad screen with disarming indication:
DISARMING...
** Indication of Arming Rejection**
If during arming a reason for which arming is impossible is detected, the information on the arming rejection and
the reason are displayed on the keypad screen.
In addition, to indicate the arming rejection the sound indication is used: four single sound signals.
The first line of the keypad screen displays the phrase
≪
ARMING REJECTION
≫
.
The second line of the keypad screen displays one possible reason for rejection:
∙
PAY FOR SECURITY!
∙
220V NOT CONNECTED
∙
NO IP CONNECTION
∙
OPEN CASE!
∙
NN ZONE FAULT
∙
NN ZONE ALARM
Correspondence of the phrases displayed in case of rejection according to the reasons that caused the
fault is given above.
The screen indication of the rejection is displayed for 5 seconds, after which the keypad screen switches to the
standby mode corresponding to the device security state.
20
