Getting Information about Site Status
To get information about a site status press
i
button:
∙
if all device partitions are disarmed, then green LED is lighted;
∙
if some partitions are armed, and others are disarmed, the keypad will display error, since it is necessary to
clearly specify the number of the partition, which status shall be received;
∙
if the device configuration does not have partitions, then the device will display an error;
Getting Information about Partition Status
To get information about a partition status press the partition number button and
i
button:
∙
if the partition is armed, then red LED will be lighted;
∙
if the partition is disarmed, then green LED will be lighted;
∙
if the device configuration does not have a partition with such a number, an error is displayed.
2.4.3
Panic Button
If the device configuration permits the use of the keypad as a panic button, then for activation it is necessary to
press and hold the “houses” button for 3 seconds. The panic button pressing is confirmed by turning on of green
and red LEDs for 1 second accompanied by sound.
If the device configuration prohibits the use of the keypad as a panic button, then the keypad will display an error.
2.4.4
Backlight and Sound Turning Off
“CN-Keypad” can turn on and off the sound and backlight.
To turn on or turn off the sound confirmation of pressing the buttons, simultaneously press and hold “#” and “9”
buttons. To turn the backlight on or off, simultaneously press and hold “#” and “0” buttons.
2.5
Wireless Keyfob
Wireless keyfob, as TM key, is assigned to a user. With a single TM-key it is possible to arm or disarm one partition.
If one user has to be able to arm or disarm several partitions at the same time, then the appropriate rules shall be
set in the “Automatic controls” section.
The keyfob is equipped with a panic button. If the button is pressed, the device will create an alarm event.
2.5.1
MyAlarm Mobile Application
– is a mobile application for working with security alarm.
The MyAlarm application is available only to security company customers.
With the help of the mobile application, it is possible to control the state of “Nord GSM” devices, operating over
GPRS or Ethernet. To do this, it is necessary to give access to the site in the Security Center software to the person
in charge.
To arm or disarm from the application, click the lock icon. After that, enter the user code. More detailed information
can be found in section
on the technical support site.
24
