5
Device Configuration
A special configurator, called “Hubble”, is used to configure (change settings of) the device.
The current version of the configurator can be downloaded from the official support site of C.Nord company
(
), from page
.
The configurator is supplied as a zip-archive with the name
hubble-X.XX.zip
, where
X.XX
is digits corresponding
to the configurator version. Unpack the archive to the hard drive of the computer, preferably - to the root folder.
If you cannot unzip the archive to the root of the disk for some reason, unpack it to a folder in the
name of which there are no Cyrillic symbols and spaces. If this condition is not met, then the device
configurator will not work correctly.
The executable configurator file is called
hubble.exe
, this file shall be run to change the device settings.
The Hubble configurator is intended for changing the settings of the following devices: Nord GSM, Nord
RF, Nord LAN, Soyuz GSM, Soyuz PCB GSM, TR-100 GSM IV and Serzhant GSM.
To start configuring the device, it is necessary to connect it to the computer via USB and run the configurator. In
order for the configurator to be more convenient to run, it is recommended to place a shortcut for launching it on
the desktop or in a folder of frequently used programs.
After the configurator is started, it automatically detects the device connected to the computer, checks the software
version installed on the device, and loads the device settings.
If the version of the software installed on the device does not match the version required for the configurator, an
error message will be displayed asking you to update the software on the device. In this case, it is necessary to shut
down the configurator and update the software on the device as described in the
section.
5.1
Control Panel and Tab Panel
5.2
Control Panel
The control panel is located at the top of the configurator main window:
Figure 47: Control panel
The following information is displayed on the left side of the control panel:
∙
device type;
∙
device software version;
∙
software version of the wireless expander, if it is connected;
∙
site number, specified in the device settings;
∙
device serial number. The serial number of the device is assigned to it during production and is unique for
the entire population of devices manufactured by the C.Nord company.
The “Read” button is designed to load the settings, that are currently stored in the device, into the configurator
interface. It shall be remembered that if you make any changes in the device settings in the configurator, and then
click on the “Read” button, all changes will be lost: the settings that were made in the configurator will be replaced
with the settings loaded from the device.
48
