Operator manual
Page 9 - 44
Initial version : 11/08
Lastest revision : -
5.3.4 Output conveyor parameter
Press the button "CONVEYOR" to have access to the conveyor parameters.
Three adjustments are available :
1 - Conveyor advances selection.
Adjust the conveyor advance (1 to 30) to obtain the space desired between the booklets.
1 = small space
29 = long space
30 = continuous advance
Determine the value through the numerical keypad, validate "
V
".
2 - Booklet offsetting on conveyor selection.
This function allows to offset a booklet every x booklets
in order to count the booklets more
easily.
x being the entered value.
1 = aligned (no offset)
2 = every second set offset
3 = 1 – 2, 3rd is offset
7 = 1 – 2 – 3 – 4 – 5 – 6, the 7th is offset
Maximum is 250
Determine the value through the numerical keypad. Validate "
V
".
3 - Conveyor full option selection.
Cancel the conveyor full detection. The machine does not stop even if the
conveyor is full.
Conveyor full detection. The machine stops when the conveyor is full.
"
V
" Validation of the adjustment parameters entered in the different screens.
"
X
" Cancel the last values entered in the defined job.
1
3
2
