4
Follow these simple steps to start using the CS4MX within minutes:
1) Insert the lower stem into the upper stem (first press in the spring clip).
2) Twist the locking device so that the stem is locked at the required length.
3) Coil the search-head lead around the stem.
4) Plug the search-head lead into the socket on the control box.
5) Remove the battery compartment cover by loosening the four retaining screws.
6) Fit 8 x AA batteries to the battery holder being careful to observe polarity
and good contact.
7) Rotate the Discrimination Level control 1 to number 4 on the scale.
8) Set the Ground Control to ‘AUTO’.
9) Switch on and rotate the Sensitivity control to number 6 on the scale.
10) START DETECTING... metal targets give a sharp audio signal from the
loudspeaker... signals from small pieces of iron rubbish are ignored... switch to
pinpoint to identify the exact position of the target.
Rapid start
