HS-898
Instruction Booklet
In unlikely event of a panel display error, you need to re-set the display
system by cycling the on/off main switch. The display circuitry is independent
of the motor control system. A display console error does not affect scooter
speed control.
16
Keep in mind these rules
：
•
Release thumb levers and allow scooter to stop completely before changing from
forward to reverse, or reverse to forward.
•
When turning to corner, swing front wheels widely, so back wheels will turn more tightly.
•
Use scooter only where it is safe for walting.
•
Drive in low speeds when reversing, riding dowhill, over rainp or curb, or on uneven
sukpace, downhills, ramps, curbs, or uneven surfaces.
Other Operating Information
：
Hill climbing:
You may need to use a higher speed. Turn to lower speed before going
downhill.
Down slopes:
proceed with downward slopes slowly, and set speed control in proximity
of turtle. The closer speed control is set toward turtle, the slower scooter
travels. However, this scooter will not self accelerate down hills due to the
automatic braking, taking effect should you attempt to drive too fast.
Kerb climbing:
Approach slowly from right angles to curb. A slight angle is permissible
with a 4-wheel scooter. Do not attempt greater than a 7cm curb.
If Self-Diagnostic Warning Light starts to blink, identify problem from
chart on page 17 and take action.
If the scooter breaks down and must be moved, get off scooter, engage
Free-Wheeling Lever to N, push scooter slowly to a safe location, and
push lever back to D.
