C-TECH-I, INC
USERS' GUIDE
mounting kits in the figure). Tighten them with a wrench. Fix the spout and the
faucet body up to the basin appropriately.
3.
Connect the cold and hot water connect hoses individually to the faucet body
and the spout.
4.
Revolve one end of the cold and hot inlet hoses into the other connection of
the faucet body; and the other end connect to the cold and hot water supply.
Do not use excessive force
5.
Connect the inlet hoses to the water supplies. Before connecting the inlet hose
to the indoor water supply pipe, you should pay attention to the three points as
follow:
1)
Flush the pipe;
Max 860kpa(8.6bar)
Hot
Cold
2)
There are no stings at the ends of the water supply pipe;
3)
Using other seal materials at the ends of the inlet pipe is not allowed
Maintenance:
1.
According to the water quality, periodically disconnect the aerator cover for
cleaning to avoid jam (See figure 1, figure 2 and figure 3). It will prevent the
leakages and cartridge damage if the spout jams;
2.
The water supply pressure should be 140 and 860 kpa (Contain cold water
and hot water);
3/5
