HOW TO RETURN THE UNIT FOR REPAIR
IN COMPLIANCE WITH THE NEW EUROPEAN RULES, CA-MI INDICATES SOME IMPORTANT POINTS TO PRESERVE THE HYGIENE OF
MOBILE AND OF THE PATIENTS. THESE RULES MUST BE RESPECTED IN ORDER TO GUARANTEE HYGIENE, SAFETY, QUALITY AND WELL
BEING TO ANYBODY OPERATING MOBILE.
Every returned device will be hygienically checked before repairing.
If CA-MI finds instrument not suitable for repairing due to clear signs of internal or external contamination, the same will be returned to customer with
specification of NOT REPAIRED INSTRUMENT, accompanied by an explanation letter. CA-MI will decide if contamination is due to bad functioning or
misuse. If contamination is cause for bad functioning, CA-MI will substitute MOBILE, only if a SALE RECEIPT and STAMPED GUARANTEE accompany
the same. CA-MI is not responsable for contaminated accessories, which will be replaced at customer’s expenses.
For this reson it is
MANDATORY
to carefully disinfect the external part of MOBILE and accessories with a cloth soaked in methylated spirits or
hypochlorite-based solutions. Pack the disinfect device and accessories in a bag.
We also request to specify the kind of fault, in order to speed up repairing procedures.
INSTRUCTION FOR USE
This medical device is not sterile, so, before using it, proceed with cleaning and disinfection operations indicated in the specific paragraph of this manual.
To open the HI-FLO nebulizer tighten the base of the HI-FLO nebulizer and turn the upper part in an anti-clockwise direction.
Extract the upper part and put the right quantity of medicine prescribed by the doctor into the
HI-FLO nebulizer, paying attention not exceed the max capacity indicated in the HI-FLO nebulizer.
IN CASE OF EXCEEDING FILLING, EMPTY THE NEBULIZER, CLEAN IT AND REPEAT THE OPERATION OF INSERTION OF
DRUG.
After putting drug, place back the top part over the base and tighten together.
Connect the prescribed medical accessory to the HI-FLO nebulizer. Connect air tube to the
HI-FLO nebulizer and the other end of the air tube to the air inlet of the compressor. Turn on MOBILE to start the medical treatment.
NEVER INHALE IN HORIZONTAL POSITION
NEVER BEND THE NEBULIZER OVER 60°.
Before using this device for the first time or after a long period of inactivity, always proceed to the cleaning operations, described in the dedicated
pharagraph of this user manual.
Before proceeding to the cleaning and maintenance operations and at the end of each use, remember to turn off the switch and disconnect MOBILE from
electrical power supply.
WARNING:
When MOBILE operates normally (with outsource power supply or with internal battery), no lights are on. In case of malfunctioning or error in
inserting batteries or batteries not sufficiently charged, MOBILE has a light with different colours positioned in the frontal side of MOBILE next to the
ON/OFF switch, which inform the user about the cause of the problem.
To understand properly luminous signals, please see boxes I and II which folow below.
Device operation
MOBILE can work by AC/DC adapter with universal voltage or by 8 rechargeable batteries Ni-MH type AA (not included) or by car plug cable.
Operation by AC/DC Adapter
Prepare the nebulizer HI-FLO, screwing the upper part and putting drug prescribed by doctor, then re-close the HI-FLO nebulizer and connect the
indicated medical accessory. Position device on a flat, stable and clean surface, connect universal AC/DC adapter to MOBILE by specific connector and
insert the plug of power supply cable of the power supplier into electrical network.
Connect HI-FLO nebulizer to the compressor with the air tube available, then press the ON/OFF switch to start treatment. To pause or stop the operation,
press again the ON/OFF switch.
With the AC/DC adapter is connected the unit is always electrically fed by the adapter, even if the batteries are inserted.
USE ONLY ORIGINAL AC/DC ADAPTER AND SPARE PARTS AS SPECIFIED IN THE CHAPTER OF TECHNICAL
SPECIFICATIONS
Operation by car plug cable:
Prepare the nebulizer HI-FLO, screwing the upper part and filling with medication prescribed by doctor, then re-close the nebulizer and connect the
recommended accessory. Position MOBILE on a flat, stable and clean surface, connect car plug cable to MOBILE with the DC connector and insert the
cable plug into car cigarette lighter plug.
Connect nebulizer to MOBILE with the air tube, then press the ON/OFF switch to start treatment.
To interrupt or stop the operation, press again the ON/OFF switch.
When the car plug is connected the unit is always electrically fed by the DC car plug, even if the batteries are inserted.
WARNING: Use only original car plug and spare parts as specified in the chapter of technical specifications.
Operation by rechargeable batteries (not included)
When electrical mains is not available, MOBILE can be operated by inserting 8 batteries Ni-MH type AA – 1.2V in the dedicated compartment.
www.nebulisercentre.co.uk
