TAB II – LUMINOUS INDICATIONS DURING RECHARGE OF BATTERIES
Signal of Led
Phase
Problem / Cause
Solution
Green Rapid Flashing
During recharging
Recharging in progress
Wit until recharge has been completed
Red and Green
Alternate Flashing
During recharging
- One or more batteries
fully discharged, slow
recharge cycle in progress
(max. 24hrs)
- Inversion of poles
- Wait for start of normal recharge cycle (see previous point) or
replace batteries in case it does not start within 24hrs.
- Disconnect the connector of AC/DC adapter, check the correct
position of batteries, then re-connect and start MOBILE. If problem
continues, contact technical service.
Green Fixed
During recharging
Recharging succesfully
completed
Disconnect AC/DC adapter
No light
On starting recharge
cycle
Faulty AC/DC adapter or
technical internal problem
Contact technical service
No light
During recharging
Blocked by automatic unit
protectors
Disconnect AC/DC adapter and re-connect it, then try to start a
recharge cycle. If problem continues, contact technical service.
CLEANING DEVICE
Use a soft dry cloth with not – abrasive and not – solvent detergents.
BEFORE STRATING CLEANING OPERATIONS, MAKE SURE THAT INTERNAL PARTS OF MOBILE DON’T COME INTO CONTACT
WITH LIQUIDS AND THE AC/DC ADAPTER OR BATTERIES ARE DISCONNECTED
CLEANING THE ACCESSORIES
Before undertaking and cleaning operation, switch off and unplug the unit.
CLEANING ACCESSORIES
1.
Turn the upper part of the nebulizer in an anti-clockwise direction;
2.
Disconnect the internal pisper at the base of the nebulizer using the fingers;
3.
Wash under running water with mild (non abrasive) washing-up liquid. After each treatment clean thoroughly each component of the nebulizer
(except air tube) removing medication residual and possible impurities.
Clean all parts in warm water.
Rinse thoroughly making sure that all deposits are washed away and let dry.
DISINFECTION
1.
Use denatured alcohol or a hypochlorite - based solution, easily found at chemist, to clean the accessories;
2.
After using the appliance, disassemble the nebulizer and clean all parts in warm water, rinse carefully and remove excess water using a soft cloth
and leave to dry in a clean place.
DO NOT BOIL OR PUT IN AUTOCLAVE THE AIR TUBE AND THE MASKS
After each treatment clean thoroughly each component of the nebulizer (except air tube) removing medication residual and possible impurities. Clean all
parts in warm water. Rinse thoroughly making sure that all deposits are washed away and let dry.
The device isn’t sterile. Before use carry out cleaning and disinfection operations.
The nebulizer HI-FLO, the mouthpiece and the nosepiece must be disinfected by boiling in water (for max. 10 minutes).
We suggest you disinfect the nebulizer HI-FLO, the mouthpiece and the nosepiece using cold disinfecting liquids (solutions with hypochlorite).
We suggest you disinfect the masks using cold disinfecting liquids (solutions with hypochlorite).
Dry the nebulizer using a clean cloth.
Attention:
Never use a cleaning brush or put sharp objects into the jet holes as this will damage the nebulizer.
MAINTENANCE
MOBILE
has no part requiring ordinary maintenance and/or lubrication.
It is necessary to verify operation and safety of the unit before every use:
Unpack MOBILE and
always check
integrity of plastic parts and power cord.
Make sure there are no cracks in the plastic parts, which could leave electrical components uncovered.
Verify the integrity of AC/DC adapter and power cord, to make sure they have not been damaged during previous use.
www.nebulisercentre.co.uk
