8
8
4.3
Rewinding onto 76 mm Cardboard Core
11
10
1
2
3
4
5
6
6
7
9
8
10
1
3
4
5
Figure 5 Rewinding onto 76 mm cardboard core
i
Note!
Use a cardboard core which is about 1 mm wider than the label strip.
1. Remove the spring from the rewind axle
2.
Put the first adapter (2) onto the rewind axle (4) and slide it to the disc (1).
3. Tighten the knurled screw (8).
4.
Put the second adapter (3) onto the rewind axle (4) and slide it towards the first adapter until the distance
between the outer edge of the adapter (3) and the disc (1) is a little less than the width of the cardboard core.
5. Tighten the knurled screw (9).
6. Slide the cardboard core (11) over the two adapters (2,3) until it is touching the disc (1).
7. Feed the label strip over the guide bar (5) and under the roller (10) to the rewind axle (4). Ensure that the label
strip is even with the disc (1).
8.
Using adhesive tape or label, affix the end of the label strip to the cardboard core.
Consider the rewind direction :
- The full line is valid for outside wound labels.
- The broken line is valid for inside wound labels.
9. Slide the plate (7) onto the rewind axle (4) until it stops.
10. Tighten the knurled screw (6).
The rewinder is ready for operation. If the printer carries out a paper feed the rewinder also starts to operate.
