9
4.4
Rewinding onto 40 mm Cardboard Core
9
8
1
2
3
4
5
6
6
7
8
1
4
5
Figure 6 Rewinding onto 40 mm cardboard core
i
Note!
Use a cardboard core which is about 1 mm wider than the label strip.
1. Mount the spring (2) with the screws (3) to the rewind axle (4).
2. Slide the cardboard core (9) onto the rewind axle (4) until it is touching the disc (1).
3. Feed the label strip over the guide bar (5) and under the roller (8) to the rewind axle (4). Ensure that the label strip
is even with the disc (1).
4.
Using adhesive tape or label, affix the end of the label strip to the cardboard core.
Consider the rewind direction :
- The full line is valid for outside wound labels.
- The broken line is valid for inside wound labels.
5. Slide the plate (7) onto the rewind axle (4) until it stops.
i
Note!
When using small labels it is possible that the cardboard core not covers the spring over the whole length.
In this case align the groove on the plate so that it fits to the spring of the rewind axle.
6. Tighten the knurled screw (6).
The rewinder is ready for operation. If the printer carries out a paper feed the rewinder also starts to operate.
