Emergency Stop
In the following described operating and/or error conditions an automatic
safety shutdown takes place along with an acoustic signal.
If a fatal error occurs (short-circuit in the electronics or in the motor)
the cablift will by switched off by the automatic circuit breaker in the
switch (
1
).
In this case try to switch on the cablift again. If the cablift is switched
off again please call for service.
1
Condition
Load suspension
devfice in upper end
position / Lifting the
retainer against an
obstacle / Overload
Load suspension
device in lower end
position / Lowering
the load retainer
against an obstacle
Symptoms
When the key is pressed,
the red LED and the LED that
indicates the current charge
state flash by turns;
the load suspension device
cannot be lifted
When the key is pressed,
the red LED and the LED that
indicates the current charge
state flash by turns;
the load suspension device
cannot be lowered
Error Solution
Lower the load suspen-
sion device by pressing
the key;
if necessary leave the
obstacle area or reduce
the loading
Lift the load retainer by
pressing the key;
if necessary remove the
cablift from the loading
area
CAUTION !
An over-discharge of the accumulator must be in any case avoided!
