Blow Applicator with Swing Cylinder
14
cab - Produkttechnik GmbH & Co KG
1. Loosen both screws (
1
) on the rear side of the mounting plate (
3
)
of the blow applicator type 3100H.
2. Move the cylinder unit within the longish hole (
3
) until the
dispensed label is aligned centrally to the pad.
3. Tighten the screws (
1
).
Fig. 5.1c Side Adjustment on the Hermes
1. Loosen both screws (
2
) on the front side of the blow applicator
type 3100H.
2. Move the cylinder unit within the longish holes (
1
) until in its upper
(starting) position the pad (
3
) is located slightly above the
dispense edge (
4
). The distance between the pad and the
dispense edge is recommended to be around 1 mm.
3. Tighten the screws (
2
).
Fig. 5.1d Level Adjustment on the Hermes
Level Adjustment
3
4
1
2
3
1
2
1
2
Adjusting the Level and the Sides of the Cylinder Unit on the Hermes
Side Adjustment
