15
5.3
Mounting and Dismounting the Cover
To initiate the applicator or for adjustments it is necessary to dismount the cover (2).
After these adjustments have been completed remount the cover.
!
Warning!
Do not operate the applicator without cover (2).
Dismount the cover only for service and/or adjustment purposes.
2
3
1
Dismount
1. Loosen screw (3).
2. Lift cover (2).
Mount
3. Move the cover (2) over the cylinder assembly.
4. Put in the cylinder (1) into the hole in the cover
(2).
5.
Tighten screw (3) to fix cover (2).
Fig. 9
Cover
5.4
Transportation Lock
1
3
2
1
3
2
4
3
Fig. 10
Stopper as transportation lock
When the applicator is delivered, the stopper (2) is mounted on the rod (1). With this stopper (2) the labelling position
for the operation mode "Blow on" can be adjusted.
In transit the stopper (2) is used as a transport lock.
i
Note!
To reduce the impact energy it is possible to use a stopper with cushioning (4).
Releasing the transportation lock
1. Loosen screw (3) of the stopper (2).
2. Move the stopper (2) along the rod (1) into the position as in operation mode:
-
Operation mode "Blow on":
„6.7 Adjustment of the Stopper for Blow Mode“
-
Operation mode "Stamp on" : Move the stopper (2) up to the end of the rod (1).
3.
Tighten screw (3) to fix the stopper (2) in position.
Summary of Contents for 4214 Series
Page 1: ...Service Manual 4214 MADE IN GERMANY Stroke Turn Applicator...
Page 39: ...39 9 Drawings 9 2 Pneumatic Drawing Type 4214 Fig 43 Pneumatics type 4214...
Page 40: ...40 40 9 Drawings 9 3 Labeling Position Type 4214 L Fig 44 Labeling position 4214L...
Page 41: ...41 9 Drawings 9 4 Label Position Type 4214 R Fig 45 Labeling position 4214R...
