19
3.12.2 Moving the Pad in Z-Direction
y
x
z
y
x
z
6
1 mm
5
1
2
3
4
Fig. 15
Displacement in the Z direction
Displacement in the Z direction (Height)
1. Switch off the compressed air and pull the tube out of the throttle valve (4). The cylinder extends by spring force
and is in the label transfer position.
1. Loosen screw (3) on the binder (2).
2. Turn the setting screw (1) so that the bottom side of the pad is 1 mm over the top of the dispensing plate (6) of the
printer.
3. Tighten screw (3).
4. Put the tube back into the throttle valve (4) and switch on the compressed air.
