10
10
4
Error Messages
4.1
Error Messages of the Printer
For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)
Operator's manual of the printer
Error treatment :
Clear the error results
Press the
feed
key to synchronize the label feed, remove the peeled labels manually
Press the
pause
key to quit the error state.
After error correction, the print of the label causing the error will be repeated.
4.2
Error messages of the Applicator
The following table contains an overview of error messages and their possible causes. It also suggests methods to
resolve the problem :
Error Message
Possible Cause
Vac. plate empty
Label is removed from the waiting position on the pressure roll before the signal START
is coming in.
Upper position
Label has not reached the area of the reflex sensor after 5 sec or was not detected.
Table 2
Error messages of the applicator
Error treatment :
Clear the error results
Press the
pause
key to quit the error state.
i
Notice!
In fault check adjustments and settings with help of the Service Manual.
After error correction, the print of the label causing the error cannot be repeated without re-start of the print job.
Except at the error "
Vac. plate empty"
.
In this case, the latest label will print again after quit the error with the
pause
key and then press the Enter button .
In the application mode "Apply/Print" send the signal "Print first label" or press the button
to send a printed
label to the reflex sensor position on the applicator.
