18
18
5.4
Avoiding Loss of Material (A4+T only)
!
Attention!
Loss of material!
At A4+T a media backfeed from the cutting edge to the printhead is not allowed due to the reliability of the
media transport.
Therefore every interruption of the continuos print process has the following consequences :
• The print of the current label/section will be completed. The printed label will be fed through the cutter
and will be cut. The media between printhead and cutter will remain blank.
• Upon resumption of printing the media between printhead and cutter will not be fed back. The print will
be started at the media position currently laying under the printhead.
• Following blank sections are generated, which cannot be used.
• For operation with cutter the length of the blank section is at least 50 mm for continuos material.
For structured media where the print image has to be synchronized to the media transport the loss of
material can reach a length of more than 300 mm.
To minimize the loss of material it is necessary to avoid interruptions of the continuos print process.
Interrupt the print process with the pause key only if it is absolute necessary.
Avoid print jobs with a small amount of labels/sections, especially single prints.
Optimization of the Data Transfer
If sequent labels/sections contain differing information, the internal preparation of the second sections must be
completed before the printing of the first section has been finished !
Otherwise the first section will be fed to the cutter without printing the next section. The print of the second section
begins only after cutting off the first section.
Therefore it is necessary to minimize the data to be transferred. i.e. to avoid transferring complete label descriptions
and to transfer the changing data only :
Activate In the printer driver menu
General > Print Settings > Advanced Setup > Options
the setting
"Force
optimization for all software"
.
or
For direct programming use the replace command
R
for changing data
Programming Manual.
5
Printing Operation
