CAB CSQ 401, Assembly Instructions Manual

12

12

3 Operation

3.2  Standard Operation



Switch on the printer. 
The cutter performs a synchronization action.

i

Note! 
To operate the cutter with continuous material in the printer menu 

Setup

 -> 

Labels

 -> 

Label sensor

 the setting 

Continuous media

 has to be 

selected. Otherwise no synchronization cut is carried out. 



Press 

. For synchronization the media will be moved forward and 

cut off.  
That synchronization is not necessary when the printhead was not opened 
between print jobs, even if the printer was powered off between print jobs.  



Send a print job. 
All labels in the job will be printed without stopping and be cut as chosen in 

the software : after each label, after a specific quantity of labels, or at the 

end of a print job.

i

Note!

Between the print jobs a direct cut can be released by pressing 

 on the control panel.

i

Note! 
In case the material do adhere in follow of electrostatic charge it's 
possible to mount an antistatic brush (Part No. 5977339) on the 
printer.

3.3  Cutting on Demand

In the "Cut on Demand" mode the print job will be split into steps, which can 
be released separately.



Choose 

Printing > Print on demand = 

On

. 



4. Printer Configuration

.



Send a print job.



Press 

.  

The first label will be printed and cut.



Press 

 again to print and cut the next label. 

i

Note!

The 

 function can be released alternatively by an external 

START signal when the I/O interface is installed on the printer. 



Configuration Manual of the printer.