16
16
5 Maintenance
i
Note!
When cutting through the label material instead of the label gap
remains of adhesive may accumulate on the blades. If operating in
backfeed mode, such remains of adhesive may be deposited on the
drive roller as well.
Clean often the drive roller (
Printer Operator's Manual) and
the cutter blades.
7
8
6
7. Grease the cylindrical area (7) of the circular blade (8) with an All
round-High quality Grease. For that hold a greased brush on the cylindrical
area and turn the axle (6) with a screwdriver for slotted head screws (slot
width 7 mm).
During the turning the area is all-around greased.
8. If the screw (5) was loosened during cleaning, adjust the initial state of the
cutter
5.3 on page 19.
9. Re-mount the cover sheet (1) using the screws M4x6 (2) and cover sheet
(3) using the screws M4x10 (4).
