18
N.B.: the auto close delay is set by the operator, in a range of 0 - 90 seconds. The entire programming procedure is run
at low speed.
With Dip 2 OFF = auto close disabled, the open, close and stop commands are sent with the remote control or button.
MEMORIZING TRANSMITTERS
With the door closed, hold down MEMO RX and press the desired transmitter button within 5 sec.; the courtesy lamp will
flash to confirm memorization.
Repeat for each separate transmitter. Up to 20 different codes can be stored in this way.
TO DELETE A TRANSMITTER: hold down MEMO RX until the courtesy light turns on, then press the transmitter button;
the courtesy light flashes 3 times to confirm the deletion - now release the MEMO RX button.
RESETTING MEMORY: resets memory by deleting all memorized codes - hold down MEMO RX until the courtesy light
goes out
- the courtesy light flashes 9 times to confirm that the memory has been reset - now release the MEMO RX button.
COURTESY LIGHT SIGNALS
no FLASH = transmitter to memorize.
1 FLASH = transmitter memorized.
2 FLASHES = a previously memorized transmitter is being re-memorized.
3 FLASHES = a transmitter has been deleted.
4 FLASHES = in delete mode, transmitter not memorized.
5 FLASHES = memory full.
9 FLASHES = all memorized codes deleted.
OPTIONAL ACCESSORIES
Tilt-up doors
The DUMPER automation can also be installed to tilt-up doors; in this case you must install the AU.C25 adapter to the
door as shown in figure 17.
Emergency battery kit
An emergency battery kit is available (code DUMPER.BAT) to allow the automation to work even during mains power failures.
Fit the batteries in their compartments and hook them up as shown in Figure 18.
TECHNICAL DATA
DUMPER
Power
115 - 230V AC 50/60 Hz
Power draw
1 A
Standby power draw
1W without accessories
3W with accessories
Traction/thrust
700 N
Maximum stroke
2600 mm
Accessory power
24 V =/O.5A max
Opening speed
0.12 - 0.20 m/s
Closing speed
0.12 - 0.20 m/s
Maximum load
9 sqm
Intermittency
Intensive Use
Operating temperature
-20°C/+50°C
Protection rating
IP 10
Weight
1.6 kg
Summary of Contents for DUMPER
