24
cab Produkttechnik GmbH & Co KG
Adjustment of the Transfer Ribbon Feed
Figure 7 b Adjustment of the Transfer Ribbon Feed
1
2
3
4
If creases, lines or black patches appear in the print image resulting in a poor
print quality, this may be caused by wrinkles in the transfer ribbon (
1
). To
remove the wrinkles, the tension of the ribbon should be made even from the
left to the right by moving the ribbon shield (
4
) up or down.
1. Loosen the locking screw (
3
).
2. Shift the transfer ribbon shield (
4
) sideways into the direction of the wrinkle.
Moving it to the left will increase the tension on the left.
Use the scale (
2
) provided to monitor the adjustments made. If the screw is
in position "1", the tension is highest on the outside, and if it is in position
"5" , the tension is highest on the inside.
3. After completing the adjustments, tighten the securing screw (
3
).
