CAB Hermes+ 1602, Operator'S Manual

10

10

3.3 

Mounting of the Bracket 

The Bracket is a mounting element to install a label printer on a floor stand, to integrate it in a production line. 

1

2

3

4

Fig. 6 

Mounting the bracket

1.  Loosen screws (4) and remove slot nut (2) from flanged joint (3).
2.  Put in the slot nut (2) into the guiding of the bracket (2) like picture. Use this guiding which is opposite the flange 

joint (3).

3.  Place the bracket (1) so on the flanged joint (3) that the guiding of the profile is bear on the fillet of the flanged 

joint (3) and the holes of the slot nut (2) are over the drillings of the flanged joint (3).

4.  Fix the bracket (1) with tightening of the screws (4) on the flanged joint (3). 

3.4 

Mounting of the printer

1

2

3

1

Fig. 7 

Mounting the printer 

!

Warning!

Before you mount the printer, check the hard fitting of the flanged joint.

Mind to a standing place with a flat 

and hard ground.

1.  Mount the centering screws (2) on both side of the printer chassis.
2.  Hang on the printer with the centering screws (2) into the opening of the mounted bracket (3).
3.  Fix the printer on both sides with the screws M6x14 (1) .

3 

Mounting