15
4.1.2
Inserting the Labels into the Print Mechanism
1
7
2
3
4
5
8
9
13
12
11
6
10
Figure 7
Inserting the labels into the print mechanism
1. Turn the levers (2,5) counterclockwise to lift the printheads (1,4).
1. Turn the lever (13) clockwise to lift the pinch roller (12) from the backfeed roller (11).
2. Move the guide (8) to the outermost position by turning the spindle (9) with the Allen key (3).
3. Supply a longer label strip of approx. 100 cm.
4. Guide label strip (6) to the print unit as shown in Figure 8. The broken line shows the path for inside wound labels.
5. Guide label strip through the label sensor (10) to the peel-off edge (7) and push it against the chassis.
6. Move the guide (8) against the label strip by turning the spindle (9).
7. Forward the label strip over the peel-off edge (7), that the strip reaches back internal rewinder. Remove the labels
from the overhanging strip.
Figure 8
Label feed path
