F-2
cab Produkttechnik GmbH & Co KG
M4
Appendix F - Firmware Updates
Firmware Update Using the Ethernet Interface
For firmware update using the Ethernet interface you must use a FTP Client
that has Binary data transfer available.
Moreover a PIN must be activated on the printer (see "Printer Configuration").
1. Connect to the FTP-Server of the printer using a FTP-Client. To setup the
FTP connection you must use the
IP Address
of the printer, the username
root
and the
PIN
of the printer as password.
Using the Internet Explorer you could enter e.g. :
ftp://192.168.100.208
Click on "File" --> "Log-on as" and enter the username "root" and the PIN
of the printer as password.
2. The FTP-Server of the printer is shown.
3. Configure the FTP-Client for "Binary" transfer mode and copy the firmware
file (i.e. 289_3c12.m4) into the "system" folder of the FTP-Server. The
key lighting on the navigator pad will be switched off.
4. After the transmission has finished, the new firmware will be stored on the
printer and the
key lighting will be switched on. This indicates the
completion of the update.
5. Close the FTP-Client.
NOTICE !
If a fault occurs during update, the previous firmware setting is invalid
and the update has to be started again.