41
cab Produkttechnik GmbH & Co KG
M4
Preparation for Tear-Off Mode / Rewind Mode
M4/200R
and
M4/300R
are delivered with the rewind guide plate (
1
) mounted
for operation in rewind mode. With the optional tear-off plate the printers also
may be operated in tear-off mode. For this purpose the rewind guide plate (
1
)
must be replaced by the tear-off plate (
3
).
M4/200P
and
M4/300P
are prepared for the dispense mode. After mounting the
optional tear-off or rewind guide plate the printers also may be operated in tear-
off or rewind mode.
7. Media Loading
Fig. 7b Exchange Rewind Guide Plate / Tear-Off Plate
The exchange of the different plates can be made in a similar way as the
exchange rewind guide plate / tear-off plate :
1. Open the cover.
2. Loosen the two screws (
2
).
3. Slide the rewind guide plate (
1
) to the right as far as possible to remove the
plate from the printer.
4. Place the slotted holes on the tear-off plate (
3
) over the screws (
2
) on the
front of the printer and slide the plate to the left until it stops.
5. Tighten the two screws (
2
).
2
2
3
1
