16
16
4
Loading Material
4.5
Loading Transfer Ribbon
i
Note!
Do not insert transfer ribbon for direct thermal printing!
!
Attention!
Risk of contamination!
When inserting the transfer ribbon ensure that the coated side faces the labels, otherwise the printhead
will be dirtied.
2
1
3
Figure 17
Removing the ribbon unwinder core
Open the cover, unlock and lower the control panel and lift the print module.
Press the core (2) to the right, pull it out of the slot (1) and remove it.
4
2
5
6
Figure 18
Adapting the core
Adjust the core (2) to the width of the ribbon roll.
For that purpose press the lever (5) and move it in such a position that pointer (4) shows the required roll width on
the scale.
Slide the ribbon roll onto the core (2) against the lever (5). Ensure that the coated side of the transfer ribbon (11)
is facing to the label stock.
Press the rectangular end (6) of the core against the spring of the retainer (3) and slide the left end into the slot
(1) until it snaps in.
Lower the print module (do not slot in).