5
•
Only connect the device to other devices which have a protective low voltage.
•
Switch off all affected devices (e.g. conveyor belt) before connecting or unlinking.
•
Risk of hand injury. Wear protective gloves while PCB separating.
•
Ensure that people‘s clothing, hair, jewelry etc. do not come into contact with the exposed rotating blade.
•
In an emergency situation, actuate the emergency stop switch in the control panel by tight pressing. This inter-
rupts the voltage supply to the device.
•
The device may only be used in a dry environment, do not expose it to moisture (sprays of water, mists, etc.).
•
Do not use the device in an explosive atmosphere.
•
Do not use the device close to high-voltage power lines.
•
Work going beyond this may only be performed by trained personnel or service technicians.
•
Unauthorized interference with electronic modules or their software can cause malfunctions.
•
Other unauthorized work on or modifications to the device can also endanger operational safety.
•
There are various warning stickers on the device. They draw your attention to dangers.
Warning stickers must therefore not be removed, as then you and other people cannot be aware of dangers and
may be injured.
Danger!
Danger to life and limb from power supply.
Do not open the device casing.
1 Introduction
