8
5
Installation
5.1
Electrical Links
!
Attention!
The device and printing materials will be damaged by moisture and wetness.
Set up the device only in dry locations protected from splash water.
i
Notice!
Clean the blade with a soft cloth before you start the machine at first time!
4
5
7
3
2
1
6
Fig.4
Connections
Set up device on a level surface. For a secure stand you can change the foot highness by turning.
Put in the foot switch round connector (4) from the foot switch (7) in the 5 pin female connector (2) and tighten it.
Connect the electrical ground on the earth connection (6).
Switch off the power module (1).Connect the power cable (5) to the power input module (3) and to an earthed
socket.
5.2
Assembly of the Adjustable Platform
2
1
3
4
Fig.5
Assembly of the adjustable platform
The adjustable platform delivered with the machine is designed for use as a hand-rest, easing the placement of the
PCB on the lineal blade. Thereby it is also preventing a possible premature tiring for the user.
The adjustable platform is delivered with 3 cylinder screws, washers and an Allen Screwdriver.
1. Mount the platform (2) by inserting the screws provided into the threaded holes (1) in the frame of the
MAESTRO 4M.
Using the elongated holes in the retainer of the platform a rough height adjustment is possible.
2. By turning the knurled screw (4), the platform (3) can be raised or lowered sensitively. Rotating the knurled screw
anti-clockwise will lift up the platform.
