9
6
Switch on and Programming
i
Notice!
You can separate PCB panel with multiple cuts very softly. It means, more cuts are gentle for material and
elements on the PCB board.
6.1
Switch on and synchronize the blade
1. Switch on the device by power switch (1). LED
not ready
is blinking.
i
Notice!
Are all connections ready and the device is swiched on and not in function check the emergency swith!
1
Fig.6
Power Switch
2. Press button
home
.
3. Press the foot-switch and hold it.
- Device will run to the start position or from the start position short out and back into the start position.
4. Loose the foot switch and the device is ready. LED
not ready
don't glow.
It's possible to use 9 program places.
After the first switch on the program 1 will be loaded.
Setting ex factory:
Material separation in 3 cuts,with increasing cut deepness respectively declining blade distance.
1. cut = blade distance: 0,6 mm
2. cut = blade distance: 0,3 mm
3. cut = blade distance: 0 mm
6.2
Programming
1. Press button
program
and hold it over 3 seconds.
The display of the selected program is blinking.
2. Select desired program place by the button
program
.
3. Press the button
key
for 3 seconds up to the LED
key
is blink.
4. Select cut step by the button
step
.
5. With the button
distance -
and
di
adjust the distance of the blades for this cut step.
- maximum distance = 0,6 mm
Adjusting in steps of = 0,05 mm
- minimum Distance = 0 mm
6. Select next cut step.
7. Adjust the blade distance
- Blade distance smaller the former distance and higher 0 mm; back to point 5.
- Blade distance = 0 mm or the same value as the former distance and pressing the button
step
;
closing the programming mode. LED
key
don't glow.
In case of end programming with two same distance value with a value greater 0 mm is the last cut a cut in this
distance.
Maximum 5 cuts are possible.