19
5.2
Adjusting the Printing Mechanism
Major adjustment of the printing mechanism beyond format-based settings is only required if the printhead assembly
has been removed or parts in this area have been replaced. Excluded from this is the replacement of the printhead,
after which readjustment is generally not required.
The following print quality imperfections may indicate maladjustment of the printing mechanism:
•
Print image too light
•
Print image is spotty
•
Print image lighter on one side
•
Horizontal lines not parallel to the horizontal label edges
•
Lateral displacement of the print image
•
Clear lateral drift of the transfer ribbon
i
Notice!
Print image errors can also arise from wrinkling of the transfer ribbon. This is why you should check the
transfer ribbon feed path and the head locking system for correct adjustment before making adjustments to
the printing mechanism
Assembly Instructions.
Adjustment of the printing mechanism comprises the following procedures in the order specified:
1. Preparing the printer for adjustment
2. Aligning the printhead to the print roller
3. Adjusting the printhead pressure
4. Adjusting the distance of the printhead to the paper guiding edge
5. Adjusting the transfer ribbon feed path
6.
Performing a final test
5.2.1
Preparing the Printer for Adjustment
1 2 3
3
4
4
5
Figure 15
Preparing the printer for adjustment
1. Load labels and transfer ribbon which extend across the entire printing width
2.
In the printer configuration, set the
Print speed
parameter to 100 mm/s.
3.
Move the transfer ribbon deflection to the central position (2) with the screw (1).
4. Position the plungers (4) in such a way that the adjustment screws are accessible through the holes (3) of the
square axis.
5. Loosen the screw (5) for the printhead bowing with an Allen key (1.5 mm) and turn it counterclockwise until turning
becomes perceptibly easier. This should occur after a maximum of a half a rotation.
