18
18
Parameter
Meaning
Default
Print on demand
Peel-off mode : Behavior after removing a label from the peel position
On
: The next label will be printed and peeled-off after touching
Off
: The next label will be printed and peeled-off immediately
Off
Cut mode : Behavior between the cuts
On
: After cutting the next label will be printed and cut after touching
Off
: All labels will be printed and cut nonstop
Reprint
Printing of another label with the information of the previous print job by
touching
.
This function can be executed until the print buffer is cleared with
.
Re-render:
Adaption of counter values, variable data can be newly put in.
Duplicate:
New label is identical with the last label of the print job.
Off:
No reprint
Re-render
Single label buffer
The next label will be processed only when the current one has finished
printing.
Off
Length scale
Eliminate deviations of the print length from the length set in the
programming
0,0%
Slippage correction
To correct the slippage of the media transport the positioning of the print
image will be re-adjusted to the position of the last detected label front
edge considering the programmed label distance.
Off
Table 5
Parameters of the
Setup > Printing
menu
6.1.2
Labels
Start menu.
Select
Setup > Labels.
Parameter
Meaning
Default
Label sensor
Method for detecting the starting end of the label.
Gap Sensor
: Detection using changes in the transparency between the
label and label gap.
Bottom-Reflect
: Detection using reflex marks on the bottom of the medium.
Continuous media
: Checking the existence of media only.
Gap sensor
Calibrate label sensor
To adapt the printer electronics to the label sensor and
SQUIX / EOS / HERMES Q / PX Q: the used liner material.
MACH 4S: the used liner and ribbon material.
Extrapolate labels
The positions of the labels which are between the label sensor and the
printhead are calculated from the first label recognized by the sensor
and the programmed label distance. That way those labels can be
printed although the printhead previously was open.
Off
Ignore paper end
Suppression of wrong
Out of paper
error messages when using labels with
transparent liner.
Off
Sensor unwinder
Only at HERMES Q!
On
: Sensor for monitoring the label supply roll is activated.
Off
: Sensor for monitoring the label supply roll is not activated.
On