21
6.1.5
Cutting
Only with cutter installed!
Not at HERMES Q and PX Q!
Start menu.
Select
Setup > Cutting.
i
Note!
The content of the menu is depending on the cutter type and described in the manual of the cutter.
6.1.6
Peeling-off
Not at EOS!
If peel-off module or I/O interface are not installed, access only with service key inserted.
Start menu.
Select
Setup > Peeling-off.
Parameter
Meaning
Default
Peel-off position
Shift the position of the dispensed label relative to the dispensing edge.
The setting can also be adjusted by the software.
The settings of configuration
and software are added together.
0.0 mm
Backfeed delay
Delay time between removing the label from the peel position and the
backfeed of the label.
250 ms
Table 9
Parameters of the
Setup > Peeling-off
menu