43
8.3
Label Profile
The
Label profile
function carries out a longer label advance. It saves the values measured by the label sensor here
and then prints them out in a diagram.
The printout is used to check label detection in conjunction with the optical properties of the label medium.
The printout occurs using the heat level and print speed specified in the
Setup > Printing
menu.
i
Notice!
The printout occurs without taking the label gaps into consideration. This is why endless media are most
suitable for this purpose.
Select the label sensor to be tested in the
Setup > Labels
menu
Load the label medium to be tested into the printer.
Start menu.
Select
Diagnostics > Label profile
.
The printer performs a longer label advance. The label sensor measures the transparency/reflection capacity of
the label material here. The message
Insert
appears in the display once the advance is complete.
Insert printable medium (labels, endless paper) which extends across the entire printing width.
If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
Start the diagram printout with
Continue
.
The printout can be canceled with
.
Label profile
Wed Aug 14 10:25:17 2019
cab SQUIX 4/300MP
Firmware V5.27 (Jul 25, 2019) - #164162036456
Peripheral device : None
50 mm/s - Gap Sensor - brightness 5 %
71.09mm -
σ
² 0.002mm²
1
2
3
4
5
Figure 22
Label profile
No. Information
1
Date and time of the printout
Device type
Version and creation date of the firmware
Serial number of the PCB CPU
Firmware version and serial number of the label sensor
2
Coordinate in the direction of paper flow at which the label start was detected
3
Type of peripheral device connected
4
Print speed, method of label detection (Gap sensor / Bottom-reflect sensor)
Brightness of the sensor LED during the measurement
5
Average value and variation of label distances
Table 25
Information in
Label profile
