49
9.4
Reset Settings
With the
Default settings
function all setup parameters excepting the passwords
default values.
Start menu.
Select
Extras
.
If the menu is protected via a PIN a prompt appears in the display. Enter the code number and confirm it.
Select
Reset settings
.
The display shows "Reset settings
".
Select
Continue
. The setup parameters will be reset and printer returns to the
Extras
menu.
9.5
Reset Passwords
The function
Reset passwords
allows to reset all passwords for the network services to the default values.
Start menu.
Select
Extras
.
If the menu is protected via a PIN a prompt appears in the display. Enter the code number and confirm it.
Select
Reset passwords
.
The display shows "Reset passwords
".
Select
Continue
. The passwords will be reset and printer returns to the
Extras
menu.
Function
User name
Password
Web interface access
admin
admin
FTP printing
ftpprint
FTP access to storage devices
ftpcard
card
FTP firmware update
ftpadmin
admin
Web service
soap
soap
OPC networking
opcuser
opcpass
Table 26
Default passwords
9.6
Cleaning Interval
With the parameter
Cleaning interval
an interval for the printhead cleaning can be set in steps of 100 m media passage.
If the set length of the medium (label strip, transfer ribbon) has passed the printhead and an error occurs in the flow
of the medium (e.g. label end, transfer ribbon end), the
Clean printhead!
message appears in the display.
The error message for the error which occurred is not displayed until the
Clean printhead!
message is acknowledged.
As long as no errors occur in the medium flow, no messages are displayed and the print job is continued even if the
cleaning interval has passed.
Start menu.
Select
Extras
.
If the menu is protected via a PIN a prompt appears in the display. Enter the code number and confirm it.
Select
Cleaning interval
.
Select a new value and confirm the selection with
.
