58
58
13.5.2
Print File List
The
Print file list
function creates a list of the files stored on the default storage device.
Insert printable medium (labels, endless paper) which extends across the entire printing width.
If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
Start menu.
Select
Storage > Print file list
The display shows the selection of storage devices
Select a storage device and confirm with
.
The directory of the storage device will be printed.
Contents of the printout:
•
the name of the storage device
•
information on the saved files
•
the size of the available memory area
13.5.3
Copy Files
With the
Copy files
function files can be copied from one to another storage devices.
Insert the storage devices.
Start menu.
Select
Storage > Copy files
.
Under the headline
Source
the selection of storage devices will be shown.
Select source device.
Select a folder.
Select files. One single file or all files (*.*) of the folder can be selected.
Confirm the selection with
.
Under the headline
Destination
the selection of storage devices will be shown again.
Select destination device and folder.
Confirm the selection with
.
The files are copied. The display shows the message "
Copied ... file(s) to [Destination]
"
Select
Continue
to return to the
Storage
menu.
13.5.4
Format Storage
The
Format
function can be used to delete all data from a storage device. This reformats the storage device. So you
can also use the
Format
function if the
Unknown card
error message appears when using the device.
Insert storage device
Start menu.
Select
Storage > Format storage
.
If the function is protected via a PIN a prompt appears in the display. Enter the code number and confirm with
OK
.
The display shows the selection of storage devices.
Select a storage device and confirm the selection with
.
The display shows the message
All data on the selected device will be lost.
Select
Continue
. The storage device will be formatted.
Do not remove the device from the printer during the deleting procedure.
The printer returns to the
Storage
menu.
