42
42
9
Extras
9.6
Cleaning Interval
With the parameter
Cleaning interval
an interval for the printhead cleaning can be set in steps of 100 m media passage.
If the set length of the medium (label strip, transfer ribbon) has passed the printhead and an error occurs in the flow
of the medium (e.g. label end, transfer ribbon end), the
Clean printhead!
message appears in the display.
The error message for the error which occurred is not displayed until the
Clean printhead!
message is acknowledged.
As long as no errors occur in the medium flow, no messages are displayed and the print job is continued even if the
cleaning interval has passed.
Start menu.
Select
Extras
.
If the menu is protected via a PIN a prompt appears in the display. Enter the code number and confirm it.
Select
Cleaning interval
.
Select a new value and confirm the selection with
.
9.7
Legal Notices
The
Legal notices
function shows the licenses and software libraries of third party solutions used in the printer firmware.
Start menu.
Select
Extras
.
If the menu is protected via a PIN a prompt appears in the display. Enter the code number and confirm it.
Select
Legal notices
.
The notices will be shown on the display
Select
Close
to leave the notices.
