OPERATIONS MANUAL MSS-KREC-54AC
Customer Care Australia P: 133 122 F: 1300 303 310 E: sales@cabac.com.au W: cabac.com.au
A: 8 Distribution Pl, Seven Hills NSW 2147
Customer Care New Zealand P: 8 0077 6969 F: 8 0088 6969 E: sales@cabac.co.nz W: cabac.co.nz
7
In support of our policy of continuous product improvement we reserve the right to change materials and specifications without notice. Drawings, where used, are
not to scale. All dimensions are in millimetres and sizes given are approximate. Where possible, technical MSDS data sheets are made available on the website. All
products should be installed and used in accordance with manufacturer’s instructions provided. Warning: products may be the subject of registered designs and
patents. Refer to website for terms and conditions on warranty.
1. After removing the battery from the power tool, insert it into the battery
charger. The red indicator will light up and indicate the battery is charging.
2. The green light comes on after approx. 120 mins when the battery is fully
charged.(From battery being completely flat)
3. Remove the battery from the charger and install into the handle of the power
tool sliding it into the base of the tool handle until it clicks into place. The
battery should be secured and unmoveable.
4. The charger will not operate effectively if overheated. Allow 10 minutes to
cool down between charges if charging consecutive batteries.
Battery Charging
ATTENTION
DO NOT dispose of this battery in a fire
orotherwise abuse the battery.
DO NOT short circuit battery output
terminals
DO NOT disassemble or modify the
battery. This may lead to short circuiting
the battery cells causing personal injury
or damage to the battery.
Safety Instructions
Follow ALL instructions to ensure safety.
WARNING
ATTENTION
Read all instructions, warnings, and
cautions carefully. Follow all safety
precautions to avoid personal injury
or property damage.
Thank you for using
KuDos® products. This manual must be read
carefully prior to operating this product. Special attention should be paid
to the section “Safety Instructions”. Damages and injuries caused by
improper use of this product are
NOT included in our warranty. We
would like to remind you to work safely and to keep this manual on hand.
Always wear safety goggles when
operating this product. Projectiles or
hydraulic fluid can cause serious
injuries.
This product is
NOT an insulator and
cannot be used near energized
conductors.
Do not use this tool on glass, plastic,
wood or any other materials which
could shatter.
Do not exceed
equipment ratings.
1
