Shower Seat
90° Elbow
Wrap teflon tape around
the 90° elbow. Then
screw it into the shower
holder.
Attention:keep two open
ends face downwards.
Inlet Tubes
Connect the inlet tubes
of proper length.
Mounting Plate
Adjust the shower seat
with level bar to keep it in
a horizontal position.
Take the fixation holes on
the mounting plate as
benchmark to make
marks on the wall.
Drill six Ø8 holes at
the marked positions.
Anchors
Self-tapping
Screws
Insert the anchors
into Ø8 holes.
Lightly fix the shower
holder to wall by
self-tapping screws.
Level adjustment
on the top surface
Vertical adjustment
at the front side
Adjust the shower
seat with level bar,
then tighten
self-tapping screws.
Alternatively, slot the
wall first with the
size of shower seat
and mounting plate,
then install the shower
holder into the slot.
Protective
Sheath
Turn on water to
test pressure, check
each joint, ensure
there is no leakage.
Then put on the
protective sheath.
