-4-
-21-
Q:
The Vacuum Pump starts, but no air is being remove from the
vacuum bag.
1. For the best results, always use Cabela’s
brand vacuum bags.
2. Be sure that the bag is inserted properly.
The open end of the bag should be centered
within the oval
Vacuum Chamber Seals
.
Be sure not to cover the
Vacuum Port
opening (Figure G).
3. The bag may have a leak. If there is a
leak in the bag, air will be pulled into the
bag from the outside. Check for tears or
punctures. If you are using a bag that was
made from a roll of material, double check
that the seal on the end of the bag is welded
closed.
4. Slight pressure on the
Vacuum Lid
may
be necessary to create a seal at the begin-
ning of the vacuum process.
5. If none of the above steps remedy the
situation, contact Customer Service.
Q: The Sealing Bar melts through the bag.
1. The
Vacuum Sealer
is only intended to be used with vacuum sealing bags. For best
results, Cabela’s Vacuum Bags should be used. DO NOT USE HOUSEHOLD BAGS
with the
Vacuum Sealer
.
2. Check the condition of the
Teflon Tape
strips. Replace if needed.
3. Open the
Vacuum Lid
and allow the sealing bar to cool for 5-10 minutes. Always
leave the
Vacuum Lid
open between bags, and allow at least 20 seconds between
cycles.
4. The
Sealing Bar
time may need to be lowered. Adjust the
Seal Time Down
(-) in one
second increments and try the test process again. Refer to the
“Initial Testing of the Bag
Seal”
instructions in this booklet for more information.
5. If none of the above steps remedy the situation, contact Customer Service.
WARNING!
1.
ALWAYS DISCONNECT Vacuum Sealer
from power source before servicing, changing
accessories or cleaning the unit.
2. Plug the
Vacuum Sealer
into a standard 120
Volt, 60 Hz wall outlet. Avoid using extension
cords.
3.
DO NOT USE
the
Vacuum Sealer
if the
Power Cord, Plug
or any other parts are
damaged. If the
Power Cord
or the
Vacuum
Sealer
is damaged, call Customer Service.
DO
NOT ATTEMPT TO REPLACE THE CORD.
Be sure to not allow the
Power Cord
to drape
into your work area. Check that all parts are
operating properly, and perform the intended
functions. Check for any other conditions that
may affect the operation.
4.
NEVER
use any accessories or parts from
other manufacturers. Doing so will VOID YOUR
WARRANTY and may cause fire, electrical
shock or injury.
5. Reduce risk of unintentional starting. Make
sure the
Power Switch
is in the “OFF” position
before attaching to the power source.
6. KEEP FINGERS CLEAR
of the
Heat
Sealing Bar
and
Teflon Tape
AT ALL TIMES
,
these areas become HOT. Doing so may cause
serious injury.
7.
DO NOT
take this appliance apart; doing
so will
VOID YOUR WARRANTY
and may
result in personal injury.
8 TO PROTECT AGAINST RISK OF
ELECTRICAL SHOCK:
DO NOT
SUBMERGE
THE
VACUUM SEALER
INTO WATER OR
LIQUID. BE SURE THE
VACUUM SEALER
IS DISCONNECTED FROM THE POWER
SOURCE BEFORE CLEANING. Follow the
“Cleaning Instructions”
in this booklet.
NEVER
rinse appliance
Vacuum Sealer
under tap.
9.
NEVER LEAVE THE VACUUM SEALER
UNATTENDED.
Be safe,
DISCONNECT
the
Vacuum Sealer
from power source before
leaving the work area. Close supervision is
necessary when any appliance is used near
children. This appliance is
NOT
to be used by
children.
10.
DO NOT
let the
Power Cord
hang over
edge of work surface.
11. Be sure the
Vacuum Sealer
is on a stable
work surface. Be sure all the
Vacuum Sealer
Feet
are stable.
12.
DO N
OT
use
the
Vacuum Sealer
outdoors.
13.
DO NOT
use the
Vacuum Sealer
while
under the influence of drugs, medications or
alcohol.
14.
The
Vacuum Sealer
is ONLY intended
to be used with VACUUM BAGS. For best
results, only use the recommended vacuum
bags.
DO NOT USE HOUSEHOLD
BAGS!
Any other uses of the
Vacuum
Sealer,
other than the uses described in
this booklet, could potentially damage the
appliance and void the warranty!
SAVE THESE INSTRUCTIONS!
Refer to them often and use them to instruct others.
WARNING!
Before cleaning, assembling or disassembling the
Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS
REMOVED FROM THE OUTLET/POWER SOURCE!
READ AND FULLY UNDERSTAND ALL INSTRUCTIONS
AND WARNINGS PRIOR TO USING THIS UNIT. YOUR
SAFETY IS MOST IMPORTANT! FAILURE TO COMPLY
WITH PROCEDURES AND SAFEGUARDS MAY RESULT
IN SERIOUS INJURY OR PROPERTY DAMAGE.
REMEMBER: YOUR PERSONAL SAFETY IS YOUR
RESPONSIBILITY!
IMPORTANT SAFETY RULES
NOTE:
The
Vacuum Sealer
is ONLY intended to be used with VACUUM BAGS. For
best results, only use the recommended vacuum bags.
DO NOT USE HOUSEHOLD
BAGS!
Any other uses of the
Vacuum Sealer,
other than the uses described in this
booklet, could potentially damage the appliance and void the warranty!
Figure G
Leave 2”
Seal
Space
Vacuum Port
