Cabela's 4BGGBP, Instruction Manual

3. Place the same finger on the scanner for a second time, holding the finger in the 
    same position until there is 1 beep and  the green light flashes once. Lift your 
    finger off the scanner.
4. Place the same finger on the scanner for a third time, holding the finger in the same 
    position until there is 2 beeps and the green light flashes twice. Lift your finger off
    the scanner. Your fingerprint is now recorded.

5. If the red light flashes 3 times with 3 beeps, your fingerprint did not get recorded and 
    you will have to start over.

1. Place a recorded finger on the scanner. The green light flashes once with 1 beep.
    The white light will come on and the scan will begin.

2. If the green light flashes twice with 2 beeps, the scan has been accepted and you 
    will have 5 seconds to turn the handle to open the door.

3. If the red light flashes once, the scanner did not read your fingerprint and you must 
    try again.  If the red light flashes 3 times, the scanner read your fingerprint and did 
    not accept it.

NOTE: If 3 invalid fingerprint attempts are made in succession, the red light will flash 5 
times with 5 beeps. And you will have an automatic lockout for 60 seconds before you 
can try a scan again.
If 1 more invalid fingerprint attempt is made, the red light will flash 5 times with 5 
beeps. And you will have an automatic lockout for 5 minutes before you can try a scan 
again. 
There will be 1 beep with the green light flashing once. This means the lockout period 
is over.

  UNLOCKING THE SAFE

BACK UP KEY

Remove the cover by pressing the tab and turning the cover 
under battery installation. Insert the key in the key hole and 
turn key ¼ turn (until stopped) to unlock the safe. Rotate the 
handle and open the door.

3