OPERATION
HOW TO OPERATE TEMPERATURE LEVELS/AIR FLOW
The device is supplied with 2 separate switches - a combination that will adjust speed and
temperature. The ‘Cold Shot’ button can be pressed for an instant shot of cold air.
HOW TO USE THE NOZZLE
Using the styling nozzle for directing air and creating desired results.
SAFETY THERMOSTAT
Your dryer is fitted with a thermo cut-out. In case of over heating the dryer will stop functioning.
After cooling down, the dryer can be used again.
CLEANING
•
Make sure the device is unplugged before cleaning.
•
Clean the body of the device with care, using a damp cloth.
•
The rear filter must be kept clean. In order to remove the filter for cleaning, turn it to the left
and clean with care.
HANDY TIP
CLEAN THE REAR FILTER ON YOUR PROFESSIONAL HAIR DRYER DAILY.
CAUTION!
TO PREVENT DAMAGE TO THE DEVICE, DO NOT USE ALKALINE CLEANING
AGENTS WHEN CLEANING. USE A SOFT CLOTH AND A MILD DETERGENT.
GENERAL SAFETY PRECAUTIONS
•
DO NOT use near water.
•
DO NOT immerse the device in water or use it in an area where it could be splashed.
•
This appliance is not intended for use by young children or infirm persons unless they have been
adequately supervised by a responsible person to ensure that they can use the appliance safely.
•
Young children should be supervised to ensure that they do not play with the device.
•
Use this device only for its intended function and do not use attachments not recommended by the
manufacturer.
•
Avoid wrapping the cord around the appliance. In time, this may cause the cord to break.
•
CAUTION! The device becomes hot during use. Always avoid contact with skin.
•
Never look directly into the airflow when device is in use.
•
Do not use hair spray when the device is in use.
•
Do not use an extension cord unless the cord complies with Australia/NZ electrical
safety standards.
•
Do not use the device if the cord is damaged. In the event of damage discontinue
use immediately. If the supply cord is damaged, it must be replaced by the
authorised manufacturer.
•
Periodically inspect the power cord for signs of damage.
DANGER: UNPLUG DEVICE WHEN NOT IN USE.
