MP800 UHD Media Player Manual
Page
8
of
45
Rev. 100- 10/17/16
IR IN Jack –
A remote IR receiver may be plugged into the front panel IR jack. This allows use of the Remote
Control even when the unit may be installed in an enclosure or behind a TV where IR access is difficult. The
connections are: Tip=Signal, Ring=GND, and 5V. Inserting a plug into this jack will defeat the onboard
IR receiver.
IR Receiver –
There is an internal IR receiver just to the right of the IR input jack. Point the IR remote at this target
when accessing the OSD menu.
IR OUT Jack –
This is an IR Blaster that can be used by a custom Xapp to control external IR devices. The IR
frequency is fixed at 38kHz and most protocols can be accommodated. The connections are Tip=+5V, Ring=Signal,
Sleeve=Signal. Contact one of our sales professionals if you are interested in utilizing the IR OUT.
Mounting
The media player should be located in a well ventilated air conditioned space for best operation. The overall
dimensions of the units are 4.3” x 9.6” x 1.1”. The mounting dimensions given below are measured from center
to center of the mounting holes. The mounting holes will accommodate a #6 screw.
2.1”
9.5”
The unit has ventilation holes all along the top. Theses should remain uncovered during operation. There are no
ventilation openings on the bottom of the chassis, so it may be bolted directly to a shelf or monitor.
Note: The MP800 contains a high power processor that generates quite a bit of heat. Do not stack the MP800 on top of
other electronics or place inside of an enclosure with no air flow.
