MP800 UHD Media Player Manual
Page
13
of
45
Rev. 100- 10/17/16
GPIO Interface Programming
The MP800G can be ordered with a GPIO interface to allow customer interaction with the player using push
buttons or sensors. This allows the player to play a video, playlist or ATSC tuner channel upon receiving a
button press from the GPIO inputs of a MP800 media player. Up to eight button inputs are supported. One can
easily configure a wide variety of media to play for each button. An ‘idle loop’ video is played when the video
triggered by the button is not playing.
The actions associated with each GPIO port may be assigned by using the Tools, Button Setup menu in QSP700.
Creating the Push Button configuration files with QS Pro Designer 7X:
Start QS Pro Designer 7X on a PC that resides on the same network as the target media player, select the correct
player, click on TOOLS and then click BUTTON SETUP. Assign content via the drop down windows and then
click Load Button Setup to send the media and configuration files over the network to the player. This may take
quite some time depending upon the size of the assigned media.
If you do not have network visibility to the player, the complete configuration and media can be sent to a SD
card plugged into your PC by pressing the Publish button. This copies all necessary configuration files, videos,
pictures, layouts, etc. and places them in the proper folders on the SD card. Simply take the newly loaded SD
card and plug it into the player and the unit will begin to play the files.
