MP800 UHD Media Player Manual
Page
45
of
45
Rev. 100- 10/17/16
Manual SD Card Formatting
The easiest way to begin using the MP800 is to use the free CE labs QS Pro Designer 7X software and that is highly
recommended. If you wish to set the player up manually, that is possible as well, but will require some configuration.
Two configuration text files and six folders will need to be created on the target SD card. An example of playing
three video files in a loop is shown below.
1.
Connect the MP800 to a HD monitor.
2.
Place a SD card in the PC that contains the content you wish to play.
3.
Create the following folders on the SD card.
a.
Html/
b.
Video/
c.
Music/
d.
Picture/
e.
Playlist/
f.
MP7XXConfig/
4.
Copy your videos to the Video folder.
5.
Create the following file:
[Control]
PlaylistVersion=2.0
[List]
ENTRY1 = VIDEO, Video_File_1
*Note: Use the names of the files stored in the video folder.*
ENTRY2 = VIDEO, Video_File_2
ENTRY3 = VIDEO, Video_File_3
ENTRY4 = LOOP
Save this file as text file (let’s call it “PL1”) but without the .txt suffix in the Playlist folder.
The LOOP command will cause the files to repeat. The Video_File_X must match the file
names of your videos exactly (no spaces and capitalization matters).
6.
Create another file:
StartUpItem, Playlist, PL1
Save this file as a text file with the name “mp7xx.conf” (no .txt suffix) in the MP7XXConfig
folder. This will cause the PL1 playlist to start automatically.
7.
Remove the SD from the PC and insert into the MP800. The video files should begin to play.
This is an exacting manual process that is extremely easy when done with the QS Pro Designer 7X software. It is
available as a free download at http://www.celabs.net.
