MP800 UHD Media Player Manual
Page
6
of
45
Rev. 100- 10/17/16
Remote Control
The unit includes a remote control for accessing the On Screen Display. Press the
MENU button to bring up the OSD menu. Use the Arrow keys to navigate and press
ENTER to select an item. If you wish to exit the On Screen Display, press MENU
repeatedly until the OSD is removed.
If you require a different Video output resolution, the TV MODE button when
pressed will toggle through several options (720p 60, 720p 50, 1080i 59.94, 1080i 60,
1080p 59.94, 1080p 60, 4Kp 25, 4Kp 30, 4Kp 50, and 4Kp 60).
In the blue button section you may use:
PLAY, STOP, FWD, REV, PREV, and
NEXT.
Pressing
PLAY
will alternate between
PLAY
and
PAUSE
.
The numerical buttons may be used to enter a RF channel on the MP800T (tuner) unit.
The format is: “041” to tune in channel 4-1. To tune upper channels, use “331” to
select channel 33-1. These channel selections are temporary and will not be kept on a
power cycle. In order to keep a RF channel, it must be programmed into a playlist.
Note: Before the tuner may be used, it may be necessary to perform a RF channel
scan to populate the local channel table. An alternative is to use the fixed channel
table. This can be set on the unit OSD under Menu, Player Setup, Configuration,
Tuner Settings, and then Tuner Channel Mode.
