Turn On/Off
– Slide the switch at the rear of the camera to turn
the camera on or off. When turned on the front LEDs will
illuminate.
Charge
– Connect the supplied power supply. While the camera
is charging the red LED at the rear will illuminate. Once fully
charged the red LED at the rear will turn off.
Note:
When the camera is screwed on to the push-pull rods and in use,
take care not to twist the rod to far anti-clockwise as this may result in the
camera unscrewing and becoming disconnected from the rod.
Display Unit
CFD2810C
Note:
The display is
NOT
IP67 rated.
Care must be taken in wet
environments.